PDA

Xem đầy đủ chức năng : Gấp với xiền



Dép Xỏ Ngón
22-01-2008, 11:51 AM
The Boots

Start by folding the bill exactly in half lengthwise, shown at top.

Then, fold unevenly end-to-end, so the ends miss by about one half of an inch.
http://members.cox.net/crandall11/money/boots/b1.jpg



Ease open the end-to-end fold, (retain the crease, you'll reuse it later), and make the lengthwise fold meet the end-to-end fold line. (The bill's border should be out away from, not in towards the fold.)
http://members.cox.net/crandall11/money/boots/b2.jpg



Now fold the other end in toward the same line.

Note how this looks. The white borders around the edge of the bill are away from the last two folds you've made.

I'll refer to the vertical line where the two meet as the centerline in following steps.

http://members.cox.net/crandall11/money/boots/b3.jpg



Fold both outer edges in toward the same centerline, from the same side.

(Okay, I screwed up the picture, the one on the left has both folds, the one on the right has only one new fold.)
http://members.cox.net/crandall11/money/boots/b4.jpg



Without unfolding anything, fold the shorter of the two ends away from the centerline. Repeat this two more times until it looks like the close-up picture shown. (Simple to do, difficult to describe.) The idea here is to make that end smaller, so we can tuck it in a tight space a couple of steps from now.
http://members.cox.net/crandall11/money/boots/b5.jpg



Take the longer tab, and make a bend so that it passes underneath the shorter end. The edge that was the far left edge in the previous picture, and is now the horizontal line in the current view should be at a ninety degree angle with the centerline.
http://members.cox.net/crandall11/money/boots/b6.jpg



If you refold the centerline fold, you're here. (This picture is rotated relative to the previous picture. The centerline fold has become the top edge of the lower/front portion of the boot.)
http://members.cox.net/crandall11/money/boots/b7.jpg



Now take the shorter, pointier loose end and wrap it around the heel area of the boot.
http://members.cox.net/crandall11/money/boots/b8.jpg

babylove17
22-01-2008, 11:54 AM
gấp cái gì vậy dép................................

Dép Xỏ Ngón
22-01-2008, 11:59 AM
This is the bottom view after tucking the short end in. (Okay, look at the next picture for where to tuck it in.)
http://members.cox.net/crandall11/money/boots/b9.jpg



Once tucked in, you are nearly done. (Optionally, curl up the toes for the "elf boot" look, as shown here.)
http://members.cox.net/crandall11/money/boots/b10.jpg



Open up the folded top, and stick your finger in. Just apply pressure where needed to open up and round the upper portion of the boot. In this rear view, you'll notice that you just have to "smoosh it" towards the bottom rear to get it looking right.
http://members.cox.net/crandall11/money/boots/b11.jpg



That's all there is to it. If you want to make a symmetric pair, (shown) alter which side is long and which is short from the second step, and follow the same instructions, reverse left for right.
http://members.cox.net/crandall11/money/boots/b12.jpg

babylove17
22-01-2008, 12:04 PM
có cách gấp rồng ko vậy

Chup xấu xí
22-01-2008, 12:07 PM
Có cách gấp áo ko Dép oai !

Dép Xỏ Ngón
22-01-2008, 12:28 PM
baby: ấy chờ tớ đi tìm nhá, koan rồng hơi khó tí nè :dance:

chup: để tớ i tìm xem nào